27SC-CF-SBD Owner’s Manual
Output Configuration
Pump 2 / blower
Configuation
of Pump 2 /
Blower
1) Locate the Pump 2
(or blower) white
wire connector
(P9 for a 120V pump
or Blower)
2) Using a pair of long-nose
pliers, unplug the white
wire of the Pump 2 (or
blower) connector.
3) Reconnect the white wire
to the P17 connector
and make sure the
connector is properly
inserted.
The configuration of Pump 2 (or blower) depends on:
• The pump (or blower) voltage (120V or 240V)
• The power input voltage of the pack
Do not change anything if your pack will be powered with
240V and your Pump 2 (or blower) is a 120V pump
(or blower).
If your pack is powered with 120V and your Pump 2 (or
blower) is 120V, or if your pack is powered with 240V and
your Pump 2 (or blower) is 240V, perform the following
steps:
To Next Page
Loading...
