41SC-CF-SBD Owner’s Manual
Instructions
3 flashing dots appear on the display.
A problem has been detected. Do not enter the water! Check
and open water valves. Clean filter if necessary. Add water if
needed. Shut power off and power the spa up again to reset the
system.
Call your dealer or service supplier if problem persists.
The temperature flashes on the display.
Water temperature in the spa has reached 112˚F. Do not enter
the water! Allow water to cool down. The system will reset
automatically when water cools down to 109˚F.
Call your dealer or service supplier if problem persists.
The display is flashing.
A power failure has occurred. Press any key to stop the flashing
and reprogram your filter cycle.
Error Conditions
To Next Page
Loading...
