16
R
EFERENCE
& I
NSTALLATION
M
ANUAL
3.2.3 DATA DISPLAY MODE (LED KEYPADS ONLY)
In the Data Display Mode you can view the programmed contents of each section one digit at a time. After
entering the desired 3-digit section (see step 3 of the “How Do I Enter The Programming Mode” box on the
previous page), press the
[ENTER]
key to access the Data Display Mode. This mode will not function with
sections using the Multiple Feature Select Programming Method.
Figure 3-1: Data Display Mode (LED Keypads Only)
3.3 PROGRAMMING USING A PARADOX MEMORY KEY
Copy the programmed contents of one control panel into the Paradox Memory Key. Then copy the contents of the
Memory Key into as many control panels as you need. Each control panel is programmed in less than 3 seconds.
If used with a Spectra 1758/EX, you will have to reassign the remote controls (see page 53).
Download to DESTINATION Control Panel
1) Remove AC and battery power from the control panel.
2) Insert the Memory Key onto the serial connector labeled “
KEY
” on the Spectra control
panel to which you wish to download the contents of the memory key to.
3) Reapply AC and battery power.
4) In installer programming mode, enter section [900], then press [
ENTER
] to acknowledge.
5) When the keypad emits a confirmation beep, remove the Memory Key.
Copy to Memory Key from SOURCE Control Panel
1) Remove AC and battery power from the control panel.
2) Insert Memory Key onto the serial connector labeled “
KEY
” on the Spectra control panel
from which you wish to copy. Make sure the write protect jumper of the Memory Key is on.
3) Reapply AC and battery power.
4) In installer programming mode, enter section [902], then press [
ENTER
] to acknowledge.
5) When the keypad emits a confirmation beep, remove the Memory Key. Remove the
Memory Key’s jumper if you do not wish to accidentally overwrite the contents of the key.
Figure 3-2: Paradox Memory Key.
To Next Page
Loading...
