Spectra 1728EX - 8.5 REPORTING FORMATS; 8.5.3 ADEMCO CONTACT ID

SPECTRA SERIES 35
8.4 PARTITION ACCOUNT NUMBERS
Section [143] = Partition 1, [144] = Partition 2
All report codes are preceded by a 4-digit or 3-digit Partition Account Number to ensure correct identification in a
partitioned system. Partition account numbers can be any hexa-digit from 1 to F. To enter 3-digit account number,
simply press the
[
FORCE
]
key followed by the 3-digit account number. Also, when using 3-digit account numbers
you must use 1-digit report codes.
8.5 REPORTING FORMATS
Section [140]: 1st digit = Format for Phone #1, 2nd digit = Format for Phone #
The Spectra Control Panels can use a number of different reporting formats and each Central Station Telephone
Number can be programmed with a different reporting format. The first digit entered into section [140] represents the
reporting format used to communicate with Central Station Telephone Number 1, the second digit represents the
reporting format used to communicate with Central Station Telephone Number 2. The Back up Telephone Number uses
the same reporting format as the last Central Station Telephone Number that was dialed.
8.5.1 STANDARD PULSE FORMATS
Spectra can use Ademco slow, Silent Knight and Sescoa standard pulse reporting formats (see Table 6).
8.5.2 A
DEMCO
E
XPRESS
The Ademco Express is a high-speed reporting format, which will transmit the 2-digit (11-FF) report codes
programmed into sections [160] to [213]. Unlike other Ademco formats, the Ademco Express does not use
the Contact ID Report Codes.
8.5.3 A
DEMCO
C
ONTACT
ID
Ademco Contact ID is a fast communicator format that uses tone reporting instead of pulse reporting. This
communicator format also uses a pre-defined list of industry standard messages and report codes that will
suit most of your basic installation needs. Please refer to the "Contact ID Report Codes List" in the
Programming Guide for a complete list of these report codes and messages.
8.5.4 CONTACT ID OPTIONS
Section [136] - Dialer Options
Option [3] OFF = Programmable Codes
Option [3] ON = All Codes (default)
When using the Programmable Codes format, use the Ademco "Contact ID Report Codes List" in the Spectra
Table 5: Special Keys for Telephone Numbers
Press Action or Value
[STAY]
*
[BYP]
#
[MEM]
switch from pulse to tone dialing or vice versa
[TBL]
or
[TRBL]
4-second pause
[FORCE]
deletes current digit
[
PG
] or [
FNC
1]
inserts blank space
Table 6: Reporting Formats
Value Entered Reporting Format
1 Ademco Slow (1400Hz, 1900Hz, 10BPS)
2 Silent Knight Fast (1400Hz, 1900Hz, 10BPS)
3 SESCOA (2300Hz, 1800Hz, 20BPS)
4 Ademco Express (DTMF 4+2)
5 (Default) Ademco Contact ID
6 Pager Format