SPECTRA SERIES 7
PART 2: INSTALLATION
2.1 LOCATION AND MOUNTING
Before mounting the cabinet, push the five white nylon-mounting studs into the back of the cabinet. Pull all cables
into the cabinet and prepare them for connection before mounting the circuit board into the back of the cabinet.
Select an installation site that isn't easily accessible to intruders and leave at least 2" around the panel box to permit
adequate ventilation and heat dissipation. The installation site should be dry and close to an AC source, ground
connection and telephone line connection.
Figure 2-1A: Spectra 1725, 1725EX, 1728 and 1728EX Control Panel Overview
To Next Page
Loading...
