Spectrum DX3 - Servo Reversing

4
Servo Reversing
MODE CHANNEL
ENTER
SYSTEM
1. With the transmitter power switch on, press the MODE key to enter the Function Mode.
MODE
ENTER
SYSTEM
2. Press the MODE key until ST REV.NORM appears on the screen. The ST REV.NORM
indicates the steering servo reversing screen.
INCREASE DECREASE
CLEAR
DIRECT
+ –
3. Press the INCREASE or DECREASE key to move the cursor to the desired servo
direction (REV.NORM).
CHANNEL
ENTER
SYSTEM
4. Press the CHANNEL key once to access the throttle servo reversing screen.
5. To select the direction of the throttle servo, repeat Step 3 above.
6. Repeat Steps 2 and 3 to adjust channel 3 if needed.
DX3 Quick
Start Setup
(continued)
st
REV • NORM
–
Indicates Current Channel
ST = Steering
TH = Throttle
FN3 = Channel 3 (optional)
Indicates Current Servo Direction
–