10
Non movable stretcher support
Unscrew the pads for slide adjustment if present
Unscrew the fixation screws of the rear bumper (slide/roller side),
using a nose plier
Remove the front bumper in the same way as the rear one. If your
device is equipped with optional accessories such electric pack
and/or medical gas delivery system, do not move too far the
bumper from the stretcher support to avoid damaging of wirings
and/or pipes.
View of the lower side of the frame – Installation quotes – NOT MOVABLE STRETCHER SUPPORT
After front and rear bumpers have been removed, place the stretcher support in the desired position inside the vehicle, mark the position
of the first two fixing holes, then drill the remaining fixation points according to the following drawing (only for non-movable stretcher
support).
NOTE: Before reassembling the front and rear bumpers, install the fastener for the stretcher following the instructions of par.9.4
To Next Page
Loading...
