10 OPERATION
10.1
TRANSPORTING THE MOWER
The mower should be transported to the mowing area on a trailer or other suitable transport vehicle.
Transporting the mower on thoroughfares on its own wheels is prohibited
When loading/unloading a trailer, make sure that the edge - formed by the floor of the trailer and the ramps – is
not an obstacle for the mower. Otherwise, you need to use longer ramps.
When loading, do not allow any person to stand by the ramps or under the hanging mower if it is lifted. It may only
be hung up on places marked by the chain symbol. The loading capacity of the lifting eyes/hooks must be suitable
for the weight of the machine as quoted on the serial plate.
When transporting the mower, make sure it is properly secured. Attach fastening devices to the eyes marked by
the chain symbol on the mower.
10.2. STARTING THE ENGINE OF THE MOWER
•
Check the gasoline in the fuel tank; refuel with
unleaded gasoline BA95 if necessary.
•
Check the forward/reverse control joystick (8)
on the remote radio controller and leave in the
neutral position.
•
Switch ON the remote radio controller power
switch (1) by turning clockwise. A red lamp (11)
will illuminate on the RC.
Unless button (1) is in the ON
position, the machine will not start.
Ensure the EMERGENCY STOP button (1) on the
remote radio control is in the raised position.
Use the key to unlock and pull up the
EMERGENCY STOP button on the mower.
Wait till lamps 1 and 3 are illuminated and lamp 2 is
flashing (on the mower), then press the horn button
(12) on the remote radio controller – the mower
ignition engages. Beacon is flashing white.
Press the START button (4) on the remote radio
controller. If the engine does not start, all the
functions of the mower are locked again. To unlock
them and consequently to start the engine, press
button (3). After three unsuccessful starting cycles
machine is locked, wait for one minute
The engine is “running”, release the START button
on the remote radio controller. While the engine is
working do not use the START button again. The
beacon is flashing green.
Let the mower idle for about 2 – 3 minutes without
engaging the mowing device.
Do not stand in direction where the
mower may move while starting it
To Next Page
Loading...
