SPIDER ILD02 EFI - Maintenance Charts Overview; Mower Maintenance Schedule

Operation Manual – Spider ILD02 EFI
33 / 55
rev. 01-01-02-2021
11 MAINTENANCE AND LUBRICATION
11.1 MAINTENANCE CHART - MOWER
Machine Maintenance
Period according to the state of the
operating hours (OH) counter
X = Operator
*No later than 2
years
Daily before
operating
Every
50 OH
Every
200 OH
Every
400 OH
Visually check for oil leakage from engine and hydraulic systems
x
x
Grease all sliding bars (at least once a season)
x
Lubricate other lubrication points with dry
lubricant in a spray
x
x
Check the level of hydraulic oil in tank
x
x
Check the tyre pressure
x
x
Visually check the tension of travel V-belts
x
x
Visually check the tension of the steering chain
x
x
Check the remote control battery state of charge
x
Check the mower battery state of charge
x
Check electronic and safety devices
(emergency stop, steering, signal etc.)
x
x
Check screw and nuts tightening (visually check daily)
x
Check blade sharpness and deformation
x
x
Check the blade bolts tightening
x
Change the hydraulic oil
(first exchange after 200 OH)
x*
Change the hydraulics filter
(first exchange after 200 OH)
x*
Rinse the fuel tank, change the breather filter
x
Change the fuel filter (change more often
on extremely dusty or dirty conditions)
x
Clean cooling systems (engine, hydraulic pump)
x
Visually check hydraulic hoses, fuel hoses, cables – replace if
necessary
x
Check and adjust wheel geometry
x
Adjust the neutral position of the machine drive (hydraulic pump)
x
Check, adjust and tighten chains in the wheel suspensions
x
Adjust the blade deceleration
x
Check drive belts and mowing mechanism belts – replace if
necessary
x
Check and clean the mowing mechanism gear (belts, pulleys, belts
pulleys)
x
Check safety decals on the machine
x
Check the mowing device bearings
x
Check the blade hub
x
Check the Brake lining condition
x
Adjustment of the auxiliary drive brake by an authorized service
facility
x