Operation Manual – Spider ILD02 EFI
Engine faults and their probable solution
No connection with the remote
Check the connection and
signal, empty battery RC
Test/measure/replace the starter
relay
Charge/change battery, check
fuses and cable connections to
fuses
Drive system isn't in neutral position
("N" Led isn't lit)
Adjust the drive servo to neutral
position if not possible change
servomotor
Are the mowing blades disengaged
Disengage the mowing blades
Mowing clutch is broken (bearings
burned out)
Starter motor doesn't
work
consequently
Interrupted cabling harness
Check cabling harness and
fuses replace where need
Insufficient amount of fuel
Loosened weight of fuel hose in fuel
tank, hose sucks air
Reattach weight to the end of the
hose
Clean exchange the filter
The motor runs irregularly
Clean/exchange spark plugs
Water in the fuel, fuel system
Clean fuel system thoroughly
The engine has infiltrated/false air
reseal the joints,
fuel system/inlets/cylinder