Operation Manual – Spider ILD02 EFI
5.1
RECOMMENDED METHODS OF OPERATION
This chart shows basic information about recommended methods of cutting grass in various types of terrain. It
also describes the correct procedure of anchoring the hydrostatic stabilizing winch. However current terrain and
climatic conditions may require different methods of operation than those shown in this chart. The operator is
always responsible for choosing the most suitable method of operation especially with regards to safety. In any
case it is always absolutely necessary to comply with all safety instructions listed in this Manual.
Chart of recommended methods of operation is placed together with the basic set of tools on the machine. See
chapter 11.25 Tools
Alwa
ys
j
ee
p th
e
t
yres
in
flate
d to
the recommended pressure. Other
values may unfavourably
influence the driving
characteristics. Maximum
p
ress
u
re
–
300
j
P
a
/3,0b
ar
/
43
PSI
Check
th
e
blad
es
. Blad
es
m
u
st
b
e
properly tightened. Blades must
not be bent and the edges must
not be damaged.
Check
th
e
o
vera
ll
c
ondition o
f t
h
e
winch. The rope and the snap
hook
m
u
st
no
t
b
e
d
ama
g
e
d.
On slopes never enter the area
below or directly above the
machine.
Recommended method of cutting
on slopes up to 36 degrees
provided the operator is well
acquainted with the terrain and
t
h
ere
i
s
no
r
isk o
f t
ipping th
e
machine over.
Recommended method of cutting
on slopes up to 35 degrees
provided the operator is well
acquainted with the terrain and
t
h
ere
i
s
no
r
isk o
f t
ipping th
e
machine over.
On slopes exceeding 36 degrees
always use the stabilizing winch.
On slopes never enter the area
below or directly above the
machine.
Recommended method of cutting
around trees on slopes up to 36
degrees.
Recommended method of cutting
around trees on slopes exceeding
36 degrees. On slopes exceeding
36 degrees always use the
stabilizing winch.
Recommended method of cutting
bushes on slopes up to 36
degrees.
Recommended method of cutting
bushes on slopes exceeding 36
degrees. On slopes exceeding 36
degrees always use the stabilizing
winch.
Recommended method of cutting along roads. Never enter the area
below or directly above the machine. Danger of getting injured by
obje
cts
th
r
own b
y
th
e
blad
es
.
Caref
ull
y
c
h
eck
th
e
t
erra
in in f
r
on
t
o
f t
h
e
mower.
Po
s
ition o
f
i
m
po
rta
n
t c
o
m
pon
e
n
ts
on th
e
mac
hin
e
(
a
ir fil
ter
,
s
p
ark
plug
s
,
hydraulic by-pass allowing the disengagement of hydraulics and
consequent towing of the machine, fuse box, battery, tools)
To Next Page
Loading...
