IM-P337- 6 9 EMM Issue 2
43
25
PRES
0
8888
ON
OFF
StEAM
HEAt XXXX%
SENSR
tEMP
SENSR
COMMS
ALARM
In-PUtS
x.xxSec
xx.xxmA
dELAy
XXXX
PRES
0 CAL
PRES
25 CAL
8888
PRES
SENSR
tEMP
SENSR
ON
OFF
STEAM
HEAT
XXXX%
COMMS
ALARM
dISP
dP
X.X.X
7.3.1 dRy
Pressing the right key will display the dryness fraction. This is the dryness fraction of the saturated steam
selection. After the dryness fraction is entered the display will automatically step to the next sub menu and
show 'UNItS'.
7.3.2 UNItS
The units displayed and transmitted
can be selected between metric
(MEt), and imperial (IMP).
A summary of the units is detailed
in the Table opposite.
Select either 'MEt' or 'IMP' and
Metric Imperial
Large Small Large Small
Tot a l flo w Tonne kg Ton lb
Total energy MWh kWh MBtu kBtu
Flow rate Tonne/h kg/h Ton/h Ib/h
Power MW kW MBtu/h kBtu/h
Pressure bar g bar g psi g psi g
Temperature °C °C °F °F
7.3.3 SCALE
This works in conjunction with UNItS detailed above (7.3.2).
By selecting LARGE, only large scale units will be shown i.e. Tons/Tonnes or MW.
By selecting SMALL, only small scale units will be shown i.e. kg.
7.3.4 tOtAL
7.3.5 AtMOS PRES
Note: Values up to two decimal places can be entered.
If metric units are selected pressure units are bar absolute, for imperial units psi absolute.
7.3 bASIC DAtA Sub menu
(Display either the mass
total in kg or lb, or the steam
energy in kWh or kBtu)
Default 97%
Default
To Next Page
Loading...
