Spirax Sarco ILVA20 - METER Sub-menu

IM-P337- 6 9 EMM Issue 2
53

7.8.1 S/N
This is the factory set serial number of the ILVA20/MVT10 paired assembly and is displayed by pressing the
right key.
7.8.2 SIZE
This is factory set to match the size of the paired ILVA20, and is displayed by pressing the right key (150-300).
7.8.3 CLEAR tOtAL
This function is used to clear the total by pressing and holding the OK key for 5 seconds.
Note:  

7.8.4 SWVER
This allows the software version to be viewed.
7.8.5 SEt PASS
This allows the default pass code to be changed to a user defined value.
It is important that if the default pass code is changed that the new value is noted and kept safe.
The new pass code can be recorded on the Table in Section 12.
7.8 MEtER Sub-menu
Press and hold for 5 seconds
25
PRES
0
8888
ON
OFF
StEAM
HEAt XXXX%
SENSR
tEMP
SENSR
COMMS
ALARM
In-PUtS
x.xxSec
xx.xxmA
dELAy
XXXX
PRES
0 CAL
PRES
25 CAL
8888
PRES
SENSR
tEMP
SENSR
ON
OFF
STEAM
HEAT
XXXX%
COMMS
ALARM
dISP
dP
X.X.X
25
PRES
0
8888
ON
OFF
StEAM
HEAt XXXX%
SENSR
tEMP
SENSR
COMMS
ALARM
In-PUtS
x.xxSec
xx.xxmA
dELAy
XXXX
PRES
0 CAL
PRES
25 CAL
8888
PRES
SENSR
tEMP
SENSR
ON
OFF
STEAM
HEAT
XXXX%
COMMS
ALARM
dISP
dP
X.X.X