Matrix 908 Field Computer
35
98-01578-ENUS R2
CONSOLESTART JOB SETUPHELP MEASUREMENTSUT START JOB
6. Travel the perimeter of the application area.
While traveling, use as needed:
Pause Boundary – pauses
the mark boundary process.
A straight line will be drawn between
the pause point and the resume point.
Resume Boundary –
resumes the mark boundary
process. A straight line will be drawn
between the pause point and the
resume point.
Cancel Boundary – cancels
mark boundary process.
7. Finish the boundary:
Automatic Close – travel to within 10 feet /
3 meters of the starting point. The
boundary will close automatically (the
light blue guideline will turn black).
Manual close – press the
FINISH BOUNDARY icon to
close the boundary with a straight line
between the current location and the
starting point.
NOTE: If the minimum distance is not
traveled (50 feet / 15 meters), an error
message will pop-up.
8. Press:
►Accept – to save and manually name the
boundary
►Decline – to save and automatically name
the boundary
Delete Last Marked
Boundary
Delete Last Marked Boundary (interior or
exterior) deletes the last marked boundary from
the current job.
Delete Exterior Boundary
Delete Interior Boundary
To Next Page
Loading...
Need help?
General