(3) note
1）When loading and unloading the machine, please choose a location on a flat and firm road. In
addition, keep a sufficient distance from the roadside.
2）Use a ramp with an angle of less than 15° or less. In addition, determine the gap between the ramps
to meet the center of the rubber track
3）When loading or unloading, set the engine speed to low idle (low-speed rotation) and operate slowly
through low-speed driving
4）Remove dirt and other materials from the ground to prevent the machine from slipping on the ramp.
Remove the grease, oil or ice stuck on the ramp and keep it clean.
5）It is easy to slip and fall on rainy days, so be careful.
6）After loading the machine, use wooden blocks to keep the machine from moving, and secure it firmly
with steel wire rope or other methods.
To Next Page
Loading...