Walking mode:
When the walking mode is selected, the two handles L3 and L4 control the forward, rear outriggers, left
turn and right turn of the machine, and the walking speed can be adjusted by changing the handle range.
● Forward: Push the left and right handles forward at the same time.
● Neutral position: Loosen the two handle levers at the same time, the handle returns to the neutral
position, the crane brakes and stops walking.
● Backward: Pull the left and right handles backward at the same time.
● Turn left: Release the left handle and push the right handle bar forward.
● Turning right: Release the right handle and push the left handle bar forward.
● Rotation: Operate the two walking handles in opposite directions, and the left and right crawlers
run in opposite directions.
(S8) High-speed walking button
It is used to switch the walking speed, namely high speed and low speed; at the same time, the display
in the lower left corner of the operation panel displays the current state, and it needs to be switched to the
low speed state when turning.
(S13) Horn button/ Signal matching button
●The horn sounds: Press the horn with your hand to make a sound; loosen your hand, the horn does
not sound. Used to warn pedestrians around.
●Match the signal to the machine. When you press the horn button and the machine does not make a
sound, use this button.
(S2) Engine stop button
Used to extinguish the engine and cut off the engine oil supply.
(S1) Engine start button
Used to start the engine and connect to the engine for fuel supply.
(S5) Force button
Press the forced button, the whole machine overweight alarm, over-winding protection, anti-tilting
protection and communication failure protection are in the shielding state. The display screen only displays
the current alarm state but does not limit the action output. Mainly used for hoisting operations, when
overweight and over-rolling alarms, the crane can be returned to a safe area to continue working through
the reset button. It has the same function as the forced switch of the console.
(S11) Debug switch
To Next Page
Loading...