Maintenance Waukesha Cherry-Burrell
®
Brand C-Series Pump
01/2019 95-03008-IEC Page 31
NOTE: Hold the impeller tight against the stub shaft and rotate
the shaft one-quarter turn until the impeller pin drops and secures
the impeller.
Install the pump casing and guard
1. Place the casing over the impeller/backplate.
NOTE: If ne
cessary, use a soft rubber mallet to line up the
casing.
2. Close and tighten the clamp.
NOTE: Che
ck for strain or misalignment of piping to the casing.
Re-adjust the casing ports and/or entire motor, leveling as
necessary.
3. Assemble the cascade water fitting (part 60112+, if included).
4. Install the guard assembly and tighten it in place. Assemble
the suction and discharge lines to the casing.
Figure 51 - Impeller pin secured
Figure 52 - Install casing
Figure 53 - Install clamp
Figure 54 - Install guard assembly
To Next Page
Loading...
