Spypoint CELL-LINK - MicroSD Card Installation and Usage; Installing a MicroSD Card; Note on Continuous Recording; Inserting Your MicroSD Card

CELL-LINKSPYPOINT
8
INSTALLING A MICROSD CARD (NOT INCLUDED)
A memory card is necessary to save the photos and videos that the camera transmits to the CELL-LINK.
When your camera is connected to the CELL-LINK, the photos and videos taken by the camera will be saved
in their original format (dened by your camera) on the microSD card of the CELL-LINK. Your precious
les are therefore stored on the CELL-LINK’s microSD card. At any time, you can directly retrieve them by
removing the SD card and transferring the content to another device.
Your device requires a memory card type microSD, with a maximum capacity of 32 GB, sold separately.
Here is a table showing the approximate quantity of photos that can be recorded on the card, according
to dierent memory card capacities.
INSERTING YOUR MICROSD CARD
Before inserting the microSD card into your device, it must be formatted via a computer to ensure
proper operations. Visit www.spypoint.com/en/support if you need help formatting your microSD card.
• Open the CELL-LINK battery compartment door.
• Make sure the device is turned OFF.
• Insert the microSD card in the slot for microSD cards, the metal contacts facing the bottom (as shown).
• The card is inserted correctly when a click is heard.
REMOVING YOUR MICROSD CARD
• Before removing a memory card, always turn your device OFF to prevent les from on the card from being
deleted or damaged.
• To remove the card, push it lightly into the device until you hear a click. Then take it out of the device.
MEMORY
4 GB 8 GB 16 GB 32 GB
PHOTOS 10 MPX
1 600 3 200 6 300 12 600
NOTE
The CELL-LINK is equipped with continuous le
recording. This means that when the memory card
is full, the device continues to save your pictures
by erasing the rst recorded les.
Memory Card