7
POWER SOURCES
AA BATTERIES
This camera can be powered by 8 AA batteries
(1.5V). The use of alkaline or lithium batteries is
recommended.
To ensure maximum performance of the camera
and prevent battery leaks, we recommend the
use of new batteries. Make sure to insert each battery
with the correct polarity. (Negative or at end against
the metal spring plate) Do not mix battery type - use
ALL alkaline or ALL lithium. Do not mix old and
new batteries. Rechargeable AA batteries are not
recommended as the lower voltage provided can
cause operational issues.
LITHIUM BATTERY PACK
This camera can be powered by a rechargeable
lithium battery pack LIT-09/LIT-C-8 (sold separa-
tely). This type of battery is less affected by cold
temperatures and lasts up to 2 times longer than
alkaline batteries.
Power
RECHARGEABLE 7.4 VOLT LI-ION POLYMER BATTERY 2.0 Ah
RECYCLE OR DISPOSE OF PROPERLY
www.spypoint.com
P INTSPY INTPSPY
Models: LIT-09: Battery only
LIT-C-8: LIT-09 Battery & charger
WARNING: To reduce risk of fire or burns,
- Do not attempt to open, disassemble, or service the battery pack.
- Do not crush, puncture, short external contacts, or dispose
of in fire or water.
ATTENTION: Pour réduire les risques de feu ou de brûlures,
- Ne pas essayer d’ouvrir, désassembler, ou de réparer la pile.
- Ne pas frapper, percer, court-circuiter les contacts externes
de la pile ou mettre dans le feu ni l’eau.
EXTERNAL (12V)
This camera can also be powered by an
external 12-volt DC input such as a 12-volt
battery (KIT-12V, BATT-12V or KIT6V/12V) or a 12-
volt adapter (AD-12V), sold separately. It is impos-
sible to use a solar panel directly plugged in the
12v. jack. The camera is not built to take charge
of that kind of power supply. The use of a solar
panel directly in the camera will not recharge or
keep charge of any AAs or the lithium pack, at all.
In order to use a solar panel, this one needs to be
combined with the use of a 12v. battery as it needs
to be plugged in the 12v.
DC 12V
To Next Page
Loading...
