SRAM G2 RE User Manual

27
Lever Fluid Removal
Remove each o-ring from each bleed screw, and discard the o-rings.Remove each o-ring from each bleed screw, and discard the o-rings.
Install new o-rings onto each bleed screw.Install new o-rings onto each bleed screw.
Install each bleed screw into the lever body.Install each bleed screw into the lever body.
Separate the bladder from the reservoir cover.Separate the bladder from the reservoir cover.
Spray isopropyl alcohol on the bladder and the reservoir cover, and Spray isopropyl alcohol on the bladder and the reservoir cover, and
clean them with a shop towel.clean them with a shop towel.
Set the bladder and cover aside on a clean shop towel.Set the bladder and cover aside on a clean shop towel.
NOTICE
All components must be completely dry before reinstalling them.
Moisture residue from cleaning the bladder can leak out of the
bladder as it dries, which can be misinterpreted as a system leak.
9
Pick
10
T10 T10
11

SRAM G2 RE Specifications

General

Brand	SRAM
Model	G2 RE
Category	Bicycle Accessories
Language	English