SRAM G2 RE User Manual

33
Lever Blade Installation
Align the pushrod cam and lever blade with the lever pivot holes in the Align the pushrod cam and lever blade with the lever pivot holes in the
lever body, then insert the pivot pin through one pivot hole and use it lever body, then insert the pivot pin through one pivot hole and use it
to align the pushrod cam assembly with the lever pivot hole.to align the pushrod cam assembly with the lever pivot hole.
Push the pivot pin into the lever pivot hole and through the pushrod Push the pivot pin into the lever pivot hole and through the pushrod
cam assembly until it is centered in the lever body.cam assembly until it is centered in the lever body.
Confirm the lever return spring is seated properly in the lever. The Confirm the lever return spring is seated properly in the lever. The
outboard end of the spring must press against the lever blade, while outboard end of the spring must press against the lever blade, while
the inboard end of the spring must press against the lever body. If the the inboard end of the spring must press against the lever body. If the
return spring is not seated properly, the reach adjuster will not function return spring is not seated properly, the reach adjuster will not function
properly.properly.
Actuate the lever and check for proper function.Actuate the lever and check for proper function.
3

SRAM G2 RE Specifications

General

Brand	SRAM
Model	G2 RE
Category	Bicycle Accessories
Language	English