36
Lever Brake Hose Installation
Insert the non-threaded end of a new compression fitting over the hose Insert the non-threaded end of a new compression fitting over the hose
barb and onto the brake hose and press the compression fitting onto barb and onto the brake hose and press the compression fitting onto
the hose until it stops. the hose until it stops.
Thread the compression fitting onto the hose barb, counter-clockwise, Thread the compression fitting onto the hose barb, counter-clockwise,
until it is flush or slightly lower than the hose barb.until it is flush or slightly lower than the hose barb.
The compression fitting is reverse threaded.The compression fitting is reverse threaded.
Slide the compression nut to the compression fitting. Slide the compression nut to the compression fitting.
Apply DOT grease to the outside of the compression fitting and the Apply DOT grease to the outside of the compression fitting and the
threads of the compression nut.threads of the compression nut.
Insert the compression fitting into the lever and hold it firmly into the Insert the compression fitting into the lever and hold it firmly into the
lever. Thread the compression fitting into the lever by hand until it lever. Thread the compression fitting into the lever by hand until it
stops.stops.
4
DOT Grease
5
To Next Page
Loading...
Need help?
General
