LOWER LEG SEAL SERVICE
1
Place the tip of a downhill tire lever underneath the lower lip of the
dust wiper seal.
NOTICE
If using a flat head screwdriver, make sure it has a round shaft. A
screwdriver with a square shaft will damage the fork leg.
2
Stabilize the lower legs on a bench top or on the floor. Hold the
lower legs firmly and use downward force on the tool handle to
leverage the dust wiper seal out. Repeat on the other side.
NOTICE
Keep the lower leg assembly stable. Do not allow the lower legs
to twist in opposite directions, compress toward each other, or
be pulled apart. This will damage the lower leg.
3
Use your fingers to remove and discard the foam rings inside the
lower legs.
4
Soak the new foam rings in RockShox 15wt suspension fluid.
Reinstall new foam rings on the top bushings in the lower legs.
8
LOWER LEG SEAL SERVICE
To Next Page
Loading...
Need help?
General
