ROCKSHOX SUSPENSION SERVICE
We recommend that you have your RockShox suspension serviced by a qualified bicycle mechanic. Servicing RockShox suspension
requires knowledge of suspension components as well as the special tools and fluids used for service.
For exploded diagram and part number information, please refer to the Spare Parts Catalog available on our website at
sram.com/service. For order information, please contact your local SRAM distributor or dealer.
Information contained in this publication is subject to change at any time without prior notice. For the latest technical information,
please visit our website at sram.com/service.
Your product‘s appearance may dier from the pictures contained in this publication.
PARTS AND TOOLS NEEDED FOR SERVICE
đƫ Safety glasses
đƫ Nitrile gloves
đƫ Apron
đƫ Clean, lint-free rags
đƫ Oil pan
đƫ Isopropyl alcohol
đƫ RockShox 15wt suspension fluid
đƫ RockShox 5wt suspension fluid
đƫ Liquid O-Ring® PM600 military grease
đƫ Buzzy's® Slick Honey bike grease
đƫ Shock pump
đƫ Seal installation tool
đƫ Downhill tire lever
đƫ Rubber mallet
đƫ Schrader valve core tool
đƫ 1.5, 2, 2.5, and 5 mm hex wrench
đƫ 1.5, 2, 2.5, and 5 mm hex bit socket
đƫ 24 mm socket wrench
đƫ Torque wrench
đƫ Large internal snap ring pliers
đƫ Pick
đƫ Long plastic or wooden dowel
đƫ Syringe
đƫ Optional travel change solo air spring assembly
SAFETY INSTRUCTIONS
Always wear safety glasses and nitrile gloves when working with suspension fluid.
Place an oil pan on the floor underneath the area where you will be working on the fork.
NOTICE
Do not scratch any sealing surfaces when servicing your suspension. Scratches can cause leaks.
When replacing o-rings, use your fingers or a pick to remove the o-ring. Clean the o-ring groove and apply grease to the new o-ring.
5
ROCKSHOX SUSPENSION SERVICE
To Next Page
Loading...
Need help?
General
