EasyManuals Logo

SRAM RockShox Reba Series User Manual

SRAM RockShox Reba Series
57 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #19 background imageLoading...
Page #19 background image
REBOUND DAMPER SERVICE
1
Clamp the fork into the bicycle stand. From the bottom of the
upper tube, push the rebound shaft in until enough shaft is
exposed to hold onto with your fingers.
Use internal snap ring pliers to remove the rebound damper seal
head snap ring.
2
Remove the rebound damper and seal head assembly from the
upper tube.
3
Spray isopropyl alcohol on the inside and outside of the upper
tube. Wipe the outside of the upper tube with a rag.
Wrap a rag around a long dowel and insert it into the upper tube
to clean inside the upper tube.
4
Install a new piston glide ring on the rebound damper.
17
REBOUND DAMPER SERVICE

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the SRAM RockShox Reba Series and is the answer not in the manual?

SRAM RockShox Reba Series Specifications

General IconGeneral
BrandSRAM
ModelRockShox Reba Series
CategoryBicycle Accessories
LanguageEnglish

Related product manuals