7
Spray isopropyl alcohol on the inside and outside of the upper
tube. Wipe the outside of the upper tube with a clean rag.
Wrap a rag around a long dowel and insert it into the upper tube
to clean inside the upper tube.
8
Remove the floating seal head, washers, floating seal head topout
bumper, and air shaft guide from the air shaft.
Spray isopropyl alcohol on the air shaft and clean it with a rag.
9
Use a pick to remove the inner and outer floating seal head o-rings.
Inspect the seal head for scratches. Spray isopropyl alcohol on the
seal head and clean it with a rag.
Apply a liberal amount of grease to the new o-rings and install
them.
Do not scratch the floating seal head. Scratches can cause leaks.
10
Use a pick to remove the air piston outer o-ring.
Inspect air piston for scratches. Spray isopropyl alcohol on the air
piston and clean it with a rag.
Apply a liberal amount of grease to the new o-ring and install it.
Do not scratch the air piston. Scratches can cause leaks.
12
SOLO AIR SPRING REMOVAL
To Next Page
Loading...
