Press to select the next device (heartrate sensor).
The PowerControl is initially set to
"Suunto" heartrate sensors. If
necessary, press to select
"ANT+ Sport“ compatible sensors
("PLUS" in the display) and press
to start searching for it.
The antenna symbol blinking on
the right of the display shows that
the searching process has star-
ted.The search bar in the middle
of the display shows the progress
of the search.
If no signal is picked up, check if the sensor pads are well placed
around your chest and moistened. When the heartrate belt is found,
the PowerControl will show ”Found” on the top line, alternating with
the serial number. Press then to confirm this sensor. If the
serial number of a sensor is known, this can be entered in the SRM
software in the setup menu under "special/hardware".
Press to select the next device (speed sensor).
- Page 16 -
To Next Page
Loading...
