Turn the wheel with the magnet.
The PowerControl is initially set to
"Suunto" sensors. If necessary,
press to select "ANT+
Sport" compatible sensors
("PLUS" in the display) and press
to start searching for it.
The antenna symbol blinking on
the right of the display shows that
the searching process has star-
ted.The search bar in the middle
of the display shows the progress
of the search.
If no signal is picked up, check if the pod is switched on and the
wheel magnet is 3-5mm away from the pod. When the sensor is
found, the PowerControl will show ”Found” on the top line, alterna-
ting with the serial number. Press then to confirm this sensor.
If the serial number of a sensor is known, this can be entered in the
SRM software in the setup menu under "special/hardware".
Press switch to the pairing of a combined cadence / speed
sensor (Garmin GSC10/Trek Duotrap).
- Page 17 -
To Next Page
Loading...
