Panel description
Rear panel
3 PTT
This 6.35mm stereo input socket may be used to provide manual transmitter
activation using a footswitch or other switching device.
Close the center pin to ground to transmit a
signal.
Close the middle contact to ground to transmit an unmodulated carrier for tuning
purposes.
4 KEY
This 6.35mm stereo input socket accepts a CW key or keyer paddle. A 2-contact
(mono) plug cannot be used in this socket.
The contact assignment is determined by software.
5 USB
USB 2.0 socket. Use this socket to connect the transceiver to your personal
computer.
6 ACC
This mini-DIN socket is meant to control external devices, like power amplifiers,
external preselector or an antenna switch. Switching algorithm of these 8 control
lines (open collector outputs) is determined by software.
The maximum voltage is 24 V, the maximum current is 150 mА.
SSB-Electronic GmbH © Page 11 of 88 V2.8.1 Content is protected by Copyright.
PTT
Carrier GND
Dot/Dash
Dash/Dot
GND
To Next Page