Software settings
Setting of audio devices
A further example of audio input/output devices selection is working with digital
modes, like JT65.
In this case, in ZeusRadio the virtual audio cable is used for audio output (for
routing the signal to the JT65-HF software), as well as for input (for transmitting the
JT65-HF signal).
The same settings have to be chosen in the JT65-HF software.
In this case also the CAT-Interface has to be configured to manage PTT line, the
VFO frequency, etc.
SSB-Electronic GmbH © Page 72 of 88 V2.8.1 Content is protected by Copyright.
To Next Page
Loading...