Ssl DD889B - Remote Control Operations; Setup and Usage

-5-
1. Removing insulating sheet
If
)
)
)
.
)
)
)
.
)
)
using remote control for the first time, you
can see an insulating sheet at the bottom
side of remote control as right.
you must remove the insulating sheet as right.
Otherwise, the remote control is disabled.
2. Replace battery
If the electric energy of battery is weak,
replace it.
1 Press and hold the movable block as direction
indicated by arrow 1 as right, at one time pull
batteryl
holder out of remote control as
direction indicated by arrow 2 as right.
2 Replace the old battery by a new one with (+)
polarity side upward as right.
3 Insert the battery holder into remote control
again as right.
3 Note about using
remote control
1 You should face the emitting window of remote control towards the sensor
window of the unit.
2 Operation angle for front panel: About 30 degree
3 The distance between the emitting window of remote control and the sensor
window of the unit : <
5M .
4 Battery Warning
leakage may cause damage to remote control.1 Battery
2Do not throw batteries into fire.
.
3.To avoid risk of accident, keep batteries out of reach of children.
REMOTE CONTROL