SST SST-PFB-SLC - Page 46

SST-PFB-SLC User’s Guide
38
Listing Available Commands
Once you are talking to the scanner, type Help to view a summary of the
available commands. Not all available commands are listed in the main help.
There are several additional help commands to show the other commands.
The following table lists commonly used serial port commands.
Command Description
HelpNet Lists commands to set network parameters
HelpMas Lists commands related to DP master operation
HelpSlv Lists commands related to DP slave operation.
Refer to section 7 for information on how to use the
scanner as a DP slave.
ShowNet Displays network parameters
ShowMas Displays the DP master configuration
ShowSlv Displays the DP slave configuration. Refer to
section 7 for information on how to use the
scanner as a DP slave.
Rec2bfXmodem Upload a DP master configuration exported as a
binary file from Siemens COM PROFIBUS
UpdFlash Store the current network, DP master and DP
slave configuration into flash memory
Ver Displays the version number of the firmware
running on the scanner
RecbssXmodem Upload a DP master configuration exported as a
binary file from the SST ProfiBus Configuration
Tool
Exit Exits terminal mode and restarts module