SSZN SR6070 - Preparation before Installation

Shenzhen Sincevision Technology Co.Ltd
www.cnsszn.com
3
/
43
Quick Start Guide of SR Series ©2021 SSZN All Right Reserved
Be sure to read this guide before use.
This guide aims to provide instructions for user to use the SR series 3D cameras quickly.
For detailed user’s guide,
you can download the Hardware Manual of SR Series 3D Camera from
SSZN official home page website at http://www.cnsszn.com.
Please read the detailed user’s guide to understand the SR series 3D camera fully.
This guide is subject to change without individual notice.

Do not tear up the label, otherwise
，
we are not responsible for warranty repair.

Do not disassemble the camera, or it will damage the camera, and cause the factory
calibration data error, must be returned to the manufacturer for repair.

Be sure to read this guide carefully, incorrect operation may cause damage to the
camera.
Environmental Requirements

Keep away from the strong electromagnetic noise source such as a high-power equipment and
high-voltage line.

Avoid sharing power source with the high-power equipment.

Avoid laying the Camera cable and the Ethernet cable in parallel with the power lines.
1 Preparation before Installation
Before installation, first, please prepare the following items:

Ethernet Cable (category 6 or higher or compatible with 10GBase-T
）

Multimeter

Wire Stripping Plier

Wire Crimping plier

Flat Gasket, M4 x4

A set of Flathead Screwdrivers

A set of Cross Screwdrivers

A set of Hex Key Allen Wrench