• As for the standalone mode, to enable the automode you must
setup properly the automode component properly in the
device_config.json
• enabled: if true, the automode starts after the reset and node initialization. If
false, automode is not executed.
• nof_acquisitions: gives the number of times the automode is executed; zero
indicates an infinite loop and it is the default value
• start_delay_s: indicates the initial delay in seconds applied after reset and
before the first execution phase starts
• logging_period_s: specifies the duration in second of the datalog phase
• idle_period_s: specifies the duration in seconds of the idle phase
• Then place it in the root folder of the SD card
• If the board is battery-powered and switched off, press PWR
button to switch on the board. Press the RESET button
Automode
45
To Next Page