ST STM32 Nucleo-64-P - Connectors; USB Micro-B Connector CN1

UM2206 Rev 3 33/55
UM2206 Connectors
54
10 Connectors
Eight connectors are implemented on the STM32 Nucleo-64-P board:
• CN1: ST-LINK USB connector
• CN7, CN8, CN9 and CN10: Arduino Uno V3 connectors
• CN5 and CN6: ST morpho connectors
• CN11: External SMPS connector
10.1 USB Micro-B connector CN1
The USB connector CN1 is used to connect the embedded ST-LINK/V2-1 to the PC for
programming and debugging the STM32 Nucleo-64-P board microcontroller.
Figure 14. USB Micro-B connector CN1 (front view)
The related pinout for the USB ST-LINK connector is listed in Table 13.
Table 13. USB Micro-B pinout
Connector
Pin
number
Pin
name
Signal name
ST-LINK
MCU pin
Function
CN1
1 VBUS
5V_STLINK /
5V_USB_CHG
-5 V power
2 DM (D-) STLINK_USB_D_N PA11 USB diff pair M
3 DP (D+) STLINK_USB_D_P PA12 USB diff pair P
4ID - - -
5GND - - GND
Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.Downloaded from Arrow.com.