ST STM32 Nucleo-64 User Manual

Hardware layout and configuration UM2324
18/44 UM2324 Rev 2
VIN configuration: jumper JP2 [3-4] must be connected as showed in Figure 10.
Figure 10. JP2 [3-4]: STLK power source
E5V is the DC power coming from external (5V DC power from ST morpho connector CN7
pin 6). In this case JP2 jumper must be on pins 5 and 6 to select E5V power source on
silkscreen of JP2.
06Y9
8
9,19
92879
-3
3,121
&13,1
&13,1

ST STM32 Nucleo-64 Specifications

General

Operating Voltage	3.3 V
Arduino Compatibility	Yes
Arduino Uno V3 Connectivity Support	Yes
ST Morpho Headers	Yes
USB	Yes
mbed Enabled	Yes
Microcontroller	STM32
Package	LQFP
Core	ARM Cortex-M
Input Voltage	7V to 12V (recommended)
Digital I/O Pins	Varies by model
Analog Input Pins	Varies by model
Flash Memory	Varies by model
SRAM	Varies by model
Clock Speed	Varies by model
Power Supply	USB or external power source
Integrated Debugger/Programmer	ST-LINK/V2-1
On-board debugger	Yes
CAN	Varies by model
Ethernet	Varies by model