AN2752 Rev 6 37/40
AN2752 Setting up the development environment
39
The LCD display on the STM8 evaluation board indicates a successful debug session (see
Figure 26).
Figure 26. STM8 evaluation board
10.3.6 Follow up
Step by step, additional peripherals of STM8S and STM8AFdevices can be run, following on
from the initial debug session described above.
Many features of STM8S and STM8AFdevices are supported by dedicated hardware on the
STM8 evaluation board. The necessary software drivers (CAN driver, LIN driver, buttons,
memory cards, buzzer, etc) are delivered in the STM8 firmware library.
To Next Page
Loading...
