Stanley Easikey 250 - Initial System Programming; Initializing the Easikey 250 Controller

Initial Programming
The initialisation of the controller involves clearing its memory and assigning the number of
Editor Keys (up to 3) that will be used.
Editor Keys are used to confirm the addition, deletion or change of a user key.
Once you have set the number of Editor Keys, you cannot change the number without
clearing the Easikey 250’s memory again. However the actual Editor Keys can be removed
and added — see the sections on Adding Editor Keys and Deleting Keys. Record the number
of Editor Keys on the Programming Worksheet.
Initialising the Easikey 250
1. Power up the Easikey 250 with all three buttons held down:
SelectEditors
 Noofkeys:3

Note: This will clear the memory of the Easikey 250.
2. Change number of Editor Keys?
Press to change
number of Editor Keys
SelectEditors

 Noofkeys:2

3. Press the Left button to confirm:
Initialising



▼
EnrolEditorKey



29