Stanley Easikey 250 - Configuring Lock Time and Mode; Setting Lock Release Time; Fail-Safe vs. Fail-Secure Configuration

Lock Time and Fail-Safe / Fail-Secure Settings
Each of the two lock relays can be set to operate the lock for between 1 and 49 seconds.
Each relay may also be set to open or close when operated, allowing the use of Fail-Safe
(power to lock) or Fail-Secure (power to release) locks.
Lock 1 may also be set to operate in a Toggle function — see Set-Reset Latch for details.
Adjusting Lock Time and Fail-Safe / Fail-Secure Settings
1. Present an Editor Key:
EditorKey

:
0

 1:Y2:Y

2. Choose a door:
Press to change
Door 1 settings:
Press to change
Door 2 settings:
Lock1Time

:
3

 Fail‐Safe

3. Change the lock time?
Press to
change
tens:
Press to
change
units:
Lock1Time

:
1
0

 Fail‐Safe

4. Change the Fail-Safe / Fail-Secure Setting?
Lock1Time

:
1
0

 Fail‐Secure

Press the middle button
:
32