Stanley Easikey 250 - Set-Reset Latch Facility; Setting Up the Set-Reset Latch

Set-Reset Latch
The set-reset latch facility is available on Lock 1 only. It allows the lock relay to be set
when a valid key is presented, and reset when a valid key is presented again. This allows the
reader to be used like a toggle to operate another system.
Note: When this facility is used, the Request to Exit facility for Door 1 will no longer be
available.
Setting Up the Set-Reset Latch Facility
1. Present an Editor Key:
EditorKey

:
0

 1:Y2:Y

2. Press the Left button:
Lock1Time

:
3

 Fail‐Safe

3. Press the Middle button to select Set-Reset Latch:
Lock1Time

:
‐
‐

 Set‐ResetLatch

4. Present the Editor Key again:
Lock1TimeSaved



37