EasyManua.ls Logo

Stanley EX5500 - Configuring EX5500 via Cisco MSE; Cisco MSE Chokepoint Configuration

Stanley EX5500
30 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
EX5500 Controller Installation & Configuration Guide
22
Configuring the Controller via Cisco MSE
Follow this procedure:
1. Open the WCS and select Configure, Chokepoints.
2. Select Add Chokepoint.
3. Enter the MAC address, Name and Static IP Address.
4. Click Save.
5. Select Monitor, Maps and then the relevant campus, building and floor.

Related product manuals