3
This Pellet Burning Free Standing Fires is designed according to EN 14785:2008
WATERFORD STANLEY disclaims any responsibility for damages to the unit if installed by non-qualified personnel;
WATERFORD STANLEY is not responsible for any damage to units installed incorrectly or not used in compliance to the instructions
included in this manual;
All local regulations, including but not limited to national and European standards, must be observed when installing, operating
and servicing the unit;
For assistance, please contact your unit's supplier or installer. You must have the wood pellet stove serial number located on the
identification plate on unit's back panel ready;
The stove can be commissioned free of charge please contact your place of purchase to arrange, the first commissioning visit is
free of charge.
If you need more information about the electronics applied in the WATERFORD STANLEY pellet stoves you may find some helpful
videos on the Waterford Stanley You tube channel. https://www.youtube.com/@WaterfordStanley
Contacts for technical support:
service@Waterford Stanley.com
Waterford Stanley
Unit 401-403
IDA Industrial Estate,
Cork Rd,
Waterford
Ireland.
Setting the Language for the first time.
To set the Language to English on the controller.
Press the menu button until “ set” is displayed beside the menu button.
Press the “ +” button 4 times , display shows “configura.......”.
Press the set button twice until abbreviation for languages in the top and centre of the screen.
Press the “ +” button until abbreviation “EN” is displayed.
Press the Menu button to set the language to English.
To Next Page
Loading...
