5
2. Package content
Waterford Stanley ships the unit with the following components:
- Free standing pellet fire model K1200 kW, K1700 kW or K2300 kW;
- Access to the brochure of the online manual;
- Power cable.
2.1. Unpacking the unit
When unpacking the unit, please refer to the illustrations below. First remove the retractable bag containing the cardboard box.
Then pull the cardboard box out (Figure 1-a) by lifting it and remove the bag containing the free-standing fire unit and the
Styrofoam plates. Finally, unscrew the four parts securing the unit to the wood pallet (Figure 1-b and Figure 1-c).
a) b)
Figure 1 - Unpacking the free-standing fire unit
3. Safety precautions
Waterford Stanley is not liable for any damages to the unit if the specified precautions, warnings and operating procedures are
not followed.
Units manufactured by Waterford Stanley are easy to operate and special attention was given to their components in order to
protect users and installers against accidental damages.
The units must only be installed by an authorised engineer, who should supply the client with a relevant statement of conformity
and who shall be liable for the final installation and consequent product good operating conditions.
This unit must be used according to its intended use as specified by the manufacturer. The manufacturer is excluded from all
liability, by contract or by tort, caused by injury to people, animals or property arising from misuse or faulty installation or servicing.
After removing the packaging, verify the contents to check their integrity and completeness. If the content of the package fails to
correspond to that indicated in point 1, contact the salesperson from whom you purchased the unit.
All the unit's components guarantee its operation and energy efficiency and should only be replaced with original parts provided
by an authorised technical assistance centre.
The unit must be serviced at least once a year by the installation engineer.
This manual is provided with the product. Please keep it close to the unit.
3.1. For your safety, we recommend that:
Make sure you fully read and understand this instruction manual before using the free-standing pellet fire as a biomass heating
unit;
• Make sure that the hydraulic circuit was correctly assembled and connected to the water supply before turning on the free-
standing pellet fire;
• The free-standing pellet fire is not intended for use by children or persons with reduced physical, sensory or mental capabilities,
or lack of experience or knowledge, unless they are under supervision or have been instructed concerning the use of the unit;
To Next Page
Loading...
Need help?
General
