– 46 –
MAINTENANCE AND LUBRICATION
2. Lubrication
Lubrication is very important to maintain optimum performance and to prevent trouble.
2-1. Lubricant
The type of lubricant greatly affects the performance and durability of the printer, especially in a low temperature
environment. We recommend use of the grease and lubrication oils listed below for this printer.
Product name Maker
FLOIL GB-TS-0 Kanto Chemicals Co., Ltd.
KF96-1000CS Shinetsu Chemical Industry
Mobil 1 Mobil oil
2-2. Lubricating Method
When lubrication is carried out in assembly and disassembly, wash parts well to remove dust and dirt before lubrication.
Lubrication must be carried out regularly once every 6 months or after 1 million lines have been printed. Lubrication is
necessary irrespective of the regular lubrication whenever lubricant becomes deficient after cleaning or whenever parts
have been disassembled or replaced.
2-3. Lubricated Areas
NO. Lubricating Point Grease/Oil
[1] Rubbing surfaces of idler gear 16 × 72 × 0.5 and idler gear shaft A GB-TS-0
[2] Rubbing surfaces of gear 40 × 0.5 and gear shaft GB-TS-0
[3] Rubbing surfaces of tractor shaft and tractor bushing GB-TS-0
[4] Rubbing surfaces of tractor shaft and release lever GB-TS-0
[5] Rubbing surfaces of carriage stay and bushing 14 × 16 × 10 Mobil 1
[6] Rubbing surfaces of clutch shaft and gear 22 × 1.0 Mobil 1
[7] Rubbing surfaces of release shaft and paper chute GB-TS-0
[8] Rubbing surfaces of roller holder and lower case GB-TS-0
[9] Rubbing surfaces of ribbon cassette gear and carriage GB-TS-0
[10] Rubbing surfaces of idler gear 70 × 0.3 and carriage GB-TS-0
[11] Rubbing surfaces of idler gear B 16 × 1 - 40 × 0.3 and carriage GB-TS-0
[12] Rubbing surfaces of clutch gear and carriage GB-TS-0
[13] Rubbing surfaces of idler gear 17 × 41 × 0.3 and gear shaft C GB-TS-0
[14] Rubbing surfaces of pulley cap and pulley shaft GB-TS-0
[15] Rubbing surfaces of timing pulley and stop ring GB-TS-0
[16] Rubbing surfaces of tractor holder and tractor cover KF96-1000CS
[17] Rubbing surfaces of adjusting lever and frame GB-TS-0
[18] Rubbing surfaces of idler gear 24 × 40 × 0.5 and gear shaft GB-TS-0
To Next Page
Loading...
