2.3 Loading Paper
Refer to "4. Paper" to select roll paper that conforms to the specications.
1. Put your nger on the switch for opening the cover, and then open and raise the printer cover.
3. Press down on both sides of the printer cover to close it rmly.
When you close the printer cover, make sure that it is closed on both sides.
4. Use the tear bar to cut the extra paper.
2. Load the roll paper in the orientation shown in the gure below, and then pull the end of the roll
straight toward you.
CAUTION
When the paper is jammed, be sure to open the printer cover before removing the jammed paper.
Do not under any circumstances try to pull out the jammed paper forcefully while the printer cover
is closed. Doing so may damage parts of the printer.
- 17 -
Cover Open Switch
Printer Cover
Tear bar
To Next Page
Loading...
