3.2 Self Test
You can use a self test to check the printer’s settings.
Before you start the self test, make sure that roll paper has been properly loaded into the printer.
3.2.1 Self Test Procedure
1. Turn the printer power by holding down the FEED button and the POWER button simultaneously for
5 seconds or more.
2. The printer will print the current printer status, including the rmware version, communication mode,
and print settings.
3. The self test will nish automatically. The printer will be ready to receive data after the self test nishes.
3.2.2 Printing the Bluetooth Device Name and MAC Address
1. Follow the procedure in section 3.2.1 to perform a self test.
2. Before the self test nishes, press and hold FEED button and MODE button at the same time.
3. The printer will print the Bluetooth device name and MAC address (the contents up to the memory
switch setting information in case of the StarPRNT), and the self test will nish automatically. The
printer will be ready to receive data after the self test nishes.
Self test information
Bluetooth device name
and MAC address
Memory switch
setting information
Emulation : ESC/POS
Communication Port : Bluetooth(Auto)
Emulation : StarPRNT
Communication Port : Bluetooth (Auto)
- 21 -
To Next Page
Loading...
