Star Micronics SP500 Series - 4. Connecting Cables and Power Cord; 4-1. Connecting the Interface Cables; 4-1-1. Connecting USB Cable

– 7 –
ENGLISH
4. Connecting Cables and Power Cord
4-1. Connecting the Interface Cables
Note that the interface cables are not provided. Please use cables that meet
specifications.
CAUTION
Before connecting/disconnecting the interface cables except for the USB
cable, make sure that power to the printer and all the devices connected
to the printer is turned off. Also make sure the power cable plug is
disconnected from the AC outlet.
4-1-1. Connecting USB Cable
Affix the ferrite core onto the USB cable as shown in the illustration below and
make sure to pass the cable through the cable support as shown in the illustration.
ON
ON
OFF
OFF
ON
ON
OFF
OFF
4 cm (maximum)