– 116 –
APPENDIX
■ DIP switch Factory presetting: All ON
*1
SW No. Function ON OFF
1 Always ON Should be set on
2 Auto Cutter *1 Invalid Valid
3 Always ON Should be set on
4 Command emulation Star ESC/POS
5 USB mode *2 Printer class Vendor class
6
7 Always ON Should be set on
8
*1 The factory settings for enabling/disabling the auto cutter are as follows.
Models without auto cutter: Invalid (Switch 2 = on)
Models with auto cutter: Valid (Switch 2 = off)
Note: Do not enable the auto cutter for models without the auto cutter (i.e.,
models with a tear bar). A mechanical error will occur.
*2 USB interface only
To Next Page
Loading...
