Star TSP100 futurePRNT - Attaching Rubber Feet

– 18 –
4-2. Attaching the Rubber Feet
(1) Attach the four rubber feet in the positions
shown in the gure.
Ensure that any soiling has been completely
wiped off before attaching the rubber feet.
(2) Position the printer over the screws, etc., on
the wall and then slide it downward to set it
in place.
After setting the printer in place, check the
screws on the wall again to make sure that
they are able to support the printer’s weight.
CAUTION
• Theprinter’sweightisapproximately2.4 kg
when the largest diameter roll paper is load-
ed.
• Usescrewsonthewallthathavebothshear
strength and pulling-out strength to with-
standaforceofatleast12kgf(118 N).
(3) Push the cover open lever, and open the print-
er cover.
(4) Insert the roll paper as shown.
(1) Attach the holding plate to the printer. Then
tighten the two screws that were supplied to
secure it in place.
ø4
Flangeless screws
2 to 3 mm
ø7 or more