Star TSP700II SERIES User Manual

– 1 –
1. Unpacking and Installation
1-1. Unpacking
After unpacking the unit, check that all the necessary accessories are included in the package.
Note: The ferrite core and fastener provided with your
printer depend on your printer configuration.
Fig. 1-1 Unpacking
If anything is missing, contact the dealer where you bought the printer and ask them to supply
the missing part. Note that it is a good idea to keep the original box and all the packing materials
just in case you need to pack the printer up again and send it somewhere at a later date.
Note
Printer
Cable cover Holding plate Screws
Roll stoppers
Shaft
Paper roll Switch blind Setup sheets
CD-ROM

Star TSP700II SERIES Specifications

General

Print Speed	250 mm/sec
Resolution	203 dpi
Print Method	Direct Thermal
Paper Width	80 mm
Connectivity	USB, Ethernet, Serial, Parallel
Cutter	Guillotine (Partial Cut)